Like science labs, STEM (science, technology, engineering, and math) labs require safety and security measures, with an emphasis on safety training, personal protective equipment (PPE), standard operating procedures, engineering controls, and supervision. While hand and power tools (e.g., hammers, screw drivers, table saws, drill presses) can be found in STEM labs, many students and teachers use these tools without receiving proper safety training.
Teachers and students who use hand and power tools can be exposed to falling, flying, abrasive, or splashing objects and harmful dusts, fumes, mists, vapors, or gases. Teachers should be aware of the following engineering control, PPE, and security recommendations:
• Hand tools in the STEM lab should not be accessible to students when the teacher is not present.
• An engineering control (e.g., wood dust collection system and electrostatic dust filtration device) should be in place to filter wood dust produced by table and hand saws.
• A master power kill switch should be installed that can immediately shut down the power in case of an emergency.
• An eye wash station should be present to in case a student’s eyes are exposed to hazardous liquids or solids.
Hand and power tool safety
Before using hand and power tools and addressing security issues in the STEM lab, teachers should peruse hand and power tool safety procedures. The Occupational Safety and Health Administration’s website has a great resource on safety and security precautions and operation of hand and power tools (see Resources).
Here are some general safety precautions when using power tools, via OSHA. All hazards involved in the use of power tools can be prevented by following five basic safety rules:
1. Keep all tools in good condition with regular maintenance.
2. Use the right tool for the job. For example, don’t use a wrench to hammer in a nail.
3. Examine each tool for damage before use.
4. Operate according to the manufacturer’s instructions.
5. Provide and use the proper protective equipment.
1. Never carry a tool by the cord or hose.
2. Never yank the cord or the hose to disconnect it from the power receptacle.
3. Keep cords and hoses away from heat, oil, and sharp edges.
4. Disconnect tools when not in use, before servicing, and when changing accessories such as blades, bits, and cutters.
5. Keep all observers at a safe distance from the work area, outside of the designated work zone.
6. Secure objects with clamps or a vise.
7. Keep your finger away from the power switch when carrying a plugged-in tool to avoid accidentally turning it on.
The Centers for Disease Control and Prevention has a school-specific website that provides additional information on tools and their associated hazards (see Resources). Technology and engineering education teachers can also provide excellent safety and security training on hand and power tools.
In the end
Schools are required to provide appropriate safety training for both teachers and students prior to any work in the STEM lab.
OSHA, hand and power tools—www.osha.gov/Publications/osha3080.html
Centers for Disease Control and Prevention, hand and power tools—www.cdc.gov/niosh/docs/2004-101/chklists/r1n50p~1.htm